Quantifying the Effect of Localized Depressurization on a Deep Underground Ore Body at the Mcarthur River Mine through Cross Hole Hydraulic Testing and Groundwater Modeling

Abstract:

The McArthur River mine in northern Saskatchewan is the largest single producer of uranium in the world. Most of the ore is extracted by raisebore mining methods at depths of 530 to 600 m below ground surface where pore pressures in the fractured host sandstone and gneiss are on the order of 5 MPa. Currently, ground freezing is used to isolate the ore from ground-water sources. Localized depressurising of the freezing drifts is being considered to increase their ground-stability.

Cross-hole flow and shut-in tests in eight NQ-size coreholes were conducted in the basement rock that is adjacent to a fault contact with the overlying 500 m thick sandstone unit. The hydrogeologic parameters of basement rock in the vicinity of a freezing drift were obtained. A 15% to 25% reduction of pore pressure over a 25 m distance was observed within a three hour test period.

A detailed three-dimensional ground-water flow model was constructed to replicate the pore pressure measured in the coreholes. The pore pressure distribution simulated from the model provides the hydrogeologic input for geotechnical engineers to evaluate ground-stability and assess whether additional active depressurising should be conducted.

Citation:

Liu, H., R. Bashir, S. Axen, J. Hatley, and G. Murdock. 2010. “Quantifying the Effect of Localized Depressurization on a Deep Underground Orebody at the McArthur River Mine through Cross Hole Hydraulic Testing and Groundwater Modelling.” Proceedings of the 3rd International Conference on Uranium 40th Annual Hydrometallurgy Meeting (Saskatoon, Canada, 15-18 August), vol. 1. E.K. Lam, J.W. Rowson, and E. Özberk, eds. Québec, Canada: Canadian Institute of Mining, Metallurgy and Petroleum: p. 241

Authors:

Houmao Liu

Link to Full Text:

Depressurisation Field Testing and Modeling.pdf

  • Itasca has announced the release of FLAC2D v9 Itasca has announced the release of FLAC2D v9, revolutionizing the way we analyze and predict...
  • 6th Itasca Symposium on Applied Numerical Modeling The next Itasca Symposium will take place June 3 - 6, 2024, in Toronto, Canada....

19 11月
Getting Started with FLAC2D/FLAC3D
This training is an introduction to continuous modeling with FLAC2D and FLAC3D. At the end of the course, participants will master the ...